clock.gif (24008 bytes)

logo.gif (5818 bytes)

clock.gif (24008 bytes)
Qs_rbbr.gif (1971 bytes)

T-HR Data Logger
Qs_rbbr.gif (1971 bytes)

The T-HR is a small Single Channel High Resolution (12 bit) Temperature Datalogger with an internal sensor. The temperature sensor is mounted under a 0.6mm dome to give a relatively fast response time.

Qs_rbbr.gif (1971 bytes)

Specification:
Temperature:
Sensor Type Thermister
Linear accuracy over range ± 0.3º C (0º C to 70º C)
Repeatability ± 0.1º C
Long term stability ± 0.1º C
Logger:
Working Temperature -30º C to +70º C
Storage Temperature -30º C to +70º C
Sampling Rate
1 second minimum
10 hours maxium
in 1 second intervals
Storage capacity
64,000 8 bit samples
32,000 12bit samples
Alarms
Two independent Alarms
Triggered on any combination of six user configurable Alarm Conditions
One alarm can be configured to dial a PocketPager
Alarms can be visually checked using the Omnilog Software
Start modes
Start immediately
Start on date/time.
Stop modes
Stop when memory is full
Stop on date/time
Loop around (continues logging)
Logging Modes

 

Each channel can be set to log any combination of: 
  • Point readings
  • Average reading
  • Maximum reading
  • Minimum reading
Battery
Factory Replaceable
One ½ AA 3.6V lithium cell
Five year life. 
The data is retained in the case of battery failure.
Battery Status Monitor in OmniLog Software
Download Time 35 seconds for Full Logger
Case material 304 Stainless tube
Screw on end cap