clock.gif (24008 bytes)

logo.gif (5818 bytes)

clock.gif (24008 bytes)
Qs_rbbr.gif (1971 bytes)

mV-HR 100mV Logger

Qs_rbbr.gif (1971 bytes)The mV-HR is a small, two channel, high resolution (12 bit) Voltage Datalogger with an internal temperature sensor. 

Qs_rbbr.gif (1971 bytes)

Specification:
100mV Input:
External Connector
2 pin Switchcraft Plug (EN3C2M )
Weatherproof
IP66
Pinout
1 Positive
2 Negative
pinout2.gif (1802 bytes) View from Front of Socket or Rear of Plug
Maximum readable input voltage 110 mV
Maximum voltage input without damaging logger 10 Volts
Input Leakage Current 1nA
If the logger is connected to a computer and either input is held at mains earth potential, erroneous results can be expected due to the earth loop current. 
Internal Temperature:
Sensor Type Thermister
Linear accuracy over range ± 0.3º C (0º C to 70º C)
Repeatability ± 0.1º C
Long term stability ± 0.1º C
Logger:
Working Temperature -30º C to +70º C
Storage Temperature -30º C to +70º C
Sampling Rate
1 second minimum
10 hours maxium
in 1 second intervals
Storage capacity
64,000 8 bit samples
32,000 12bit samples
Alarms
Two independent Alarms
Triggered on any combination of six user configurable Alarm Conditions
One alarm can be configured to dial a PocketPager
Alarms can be visually checked using the Omnilog Software
Start modes
Start immediately
Start on date/time.
Stop modes
Stop when memory is full
Stop on date/time
Loop around (continues logging)
Logging Modes
Each channel can be set to log any combination of: 
  • Point readings
  • Average reading
  • Maximum reading
  • Minimum reading
Battery
Factory Replaceable
One ½ AA 3.6V lithium cell
Five year life. 
The data is retained in the case of battery failure.
Battery Status Monitor in OmniLog Software
Download Time 35 seconds for Full Logger
Case material 304 Stainless tube
Screw on end cap Plated brass
Weight 110g
Size 20mm diameter X 168mm long

Qs_rbbr.gif (1971 bytes)